WiperLock, Wireless DNA, and ZENA are trademarks of Microchip Technology Incorporated in the U.S.A. and other countries. SQTP is a service mark of Microchip Technology Incorporated in the U.S.A. Silicon Storage Technology is a registered trademark of Microchip Technology Inc. in other countries.
• Customer Support • Document Revision History DOCUMENT LAYOUT This guide describes information on evaluating the CY920 Network Media module using the Evaluation board (CE2). The document is organized as follows: • Chapter 1. “Introduction” provides a brief description of the CY920 module fea- tures.
CY920 Getting Started Guide CONVENTIONS USED IN THIS GUIDE This manual uses the following documentation conventions: DOCUMENTATION CONVENTIONS Description Represents Examples Italic characters Referenced books MPLAB IDE User’s Guide Emphasized text ...is the only compiler... Initial caps A window the Output window...
® Integrated Wi-Fi Data Sheet (DS60001278) CY920 Network Media Module Data Sheet (DS60001270) THE MICROCHIP WEB SITE Microchip provides online support via our web site at: http://www.microchip.com. This web site makes files and information easily available to customers. Accessible by most Internet browsers, the web site contains the following information: •...
Latest version of the product DS-5 V5.13 (Windows) is available; link to download DS-5 is as follows: http://www.arm.com/products/tools/software-tools/ds-5/ds-5-downloads.php License required for compiling CY920 SDK code is DS-5 Pro. When purchasing the license, it is suggested that customers should check if the license supports DS - 5 as well.
® Bluetooth v2.1 + EDR and 10/100 T Mbps Ethernet. This document is intended to help users to evaluate the CY920 Network Media module ® using the Evaluation board (CE2). It also provides procedure to perform AirPlay DLNA™ streaming. It is assumed that the user of this document has prior knowledge of Airplay and DLNA.
Stock Keeping Units (SKUs). The hardware features of the CY920 module can vary depending on the SKUs used. For more information on SKUs used in the CY920 module, refer to the Ordering Guide section in the “CY920 Network Media Module Data Sheet” (DS60001270).
Introduction CY920 MODULE TOP AND BOTTOM VIEW This section provides the top and bottom view of the CY920 module with RF shield. Figure 1-2 shows the top view of the CY920 module with RF shield. FIGURE 1-2: CY920 MODULE (TOP VIEW) Preliminary ...
Page 14
CY920 Getting Started Guide Figure 1-3 shows the bottom view of the CY920 module with RF shield. It also features the following key components: 1. Basic Connector 2. Extended Connector (optional) The extended connector is not available for certain SKUs of the CY920 module.
EVALUATION BOARD FUNCTIONALITY AND FEATURES The Evaluation board (CE2) is a development base board with all the input and output interfaces to the CY920 module.The CE2 board has the following key features, as indicated by the corresponding numbers in Figure 1-4.
Page 16
CY920 Getting Started Guide NOTES: Preliminary 2014 Microchip Technology Inc. DS50002260B-page 16...
CY920 GETTING STARTED GUIDE Chapter 2. Evaluating CY920 Board This chapter describes evaluating the CY920 module using the CE2 board. The CY920 module is not a stand-alone module and it must be hosted on an interconnect card before connecting it to the CE2 board. The following sections provide prerequisites for connecting the CE2 board and various inputs and outputs interfaces: •...
Page 18
CY920 Getting Started Guide 2. Connect the CY920 module and the interconnect card assembly to the connector X2 (200 pin SODIMM connector) on the CE2 board, see Figure 1-4. Ensure that the edge of the interconnect card must be aligned to the X2 connector and it is...
8. When the application is running, continue to press <Enter> until the “ ” sds:// shell command is displayed on the window, see Figure 2-6. Preliminary 2014 Microchip Technology Inc. DS50002260B-page 19...
Page 20
CY920 Getting Started Guide FIGURE 2-6: WINDOW DISPLAYING SHELL PROMPT Preliminary 2014 Microchip Technology Inc. DS50002260B-page 20...
Some of the CY920 module SKUs have provision for Ethernet mode. To connect the CY920 module to Ethernet mode, the set up needs an AP with Dynamic Host Control Protocol (DHCP) support. You must connect the CE2 board to the AP using an Ethernet cable.
Page 22
CY920 Getting Started Guide FIGURE 3-1: DISPLAYING ACQUIRED IP ADDRESS 7. If IP address of the DMP device is not acquired, IP address will not be displayed on the window, see Figure 3-2. FIGURE 3-2: DISPLAY WHEN IP ADDRESS NOT ACQUIRED Preliminary ...
CONFIGURING CY920 IN Wi-Fi MODE The CY920 module can be configured in two Wi-Fi modes: an unsecured (open) mode or a secured mode. The CY920 module has two U.FL connectors for connecting the external RF antennas mounted on the CE2 board.
Page 24
Figure 3-3. FIGURE 3-3: WPAPSK METHOD 9. Reboot the CY920 module and wait for the “ ” shell command to display. sds:// Ensure that the Ethernet cable is not connected. 10. Once the shell prompt is displayed, run the “...
Page 25
Optional: Users can list all the preceding commands in the Wireless_Set- file and copy all the commands to a serial terminal tool, Tera Term, to ting.txt configure the CY920 module in the WPAPSK Wi-Fi security mode, see Example 3-3, EXAMPLE 3-3: Wireless_Setting.txt FILE...
Page 26
CY920 Getting Started Guide NOTES: Preliminary 2014 Microchip Technology Inc. DS50002260B-page 26...
Ensure that the ACP 2.0C is connected to the CE2 board. 5. Open the iTunes from the iOS device or computer. If the CY920 module and the iOS device or computer is on the same network, the Airplay symbol will be lit up...
1. Set up the CE2 board, see 2.1 “Connecting CY920 Module, CE2 Board, and Interconnect Card”. 2. Configure the CY920 module network using Ethernet or Wi-Fi mode, see Chap- ter 3. “Network Configuration”. 3. Connect the computer and the CY920 module to the same network.
Need help?
Do you have a question about the CY920 and is the answer not in the manual?
Questions and answers