HP Point of Sale rp5000 Setup Manual page 6

Computer Setup (F10) Utility Guide
2
POST error occurs, the error is displayed regardless of the mode
selected. To manually switch to Post Messages Enabled during
POST, press any key (except
■
Establish an Ownership Tag, the text of which is displayed each
time the system is turned on or restarted.
■
Enter the Asset Tag or property identification number assigned by
your company to this computer.
■
Enable the power-on password prompt during system restarts
(warm boots) as well as during power-on.
■
Establish a setup password that controls access to the Computer
Setup (F10) Utility and the settings described in this section.
■
To secure integrated I/O functionality, including the serial, USB,
or parallel ports, audio, or embedded NIC, so that they cannot be
used until they are unsecured.
■
Enable or disable Master Boot Record (MBR) Security.
■
Enable or disable removable media boot ability.
■
Enable or disable removable media write ability (when supported
by hardware).
■
Solve system configuration errors detected but not automatically
fixed during the Power-On Self-Test (POST).
■
Replicate your system setup by saving system configuration
information on diskette and restoring it on one or more
computers.
■
Configure various energy-saving features including energy saver
mode, system and hard drive timeouts, power button mode, and
power LED behavior.
www.hp.com
F1 F12
through ).
Computer Setup (F10) Utility Guide