Basic Troubleshooting; Solving General Problems - HP Point of Sale rp5000 Getting Started

Point of sale system
Hide thumbs Also See for Point of Sale rp5000:
Table of Contents

Advertisement

Reconfigure your computer after installing a non–plug and
play expansion board or other option. See
Installation Problems" on page 17
Be sure that all the needed device drivers have been installed.
For example, if you have connected a printer, you need to
install a printer driver.
Remove all bootable media (diskette, CD, or USB device)
from the system before turning it on.
If you have installed an operating system other than the
factory-installed operating system, check to be sure that it is
supported on your system.
Ä
CAUTION: When the computer is plugged into an AC power
source, voltage is always being applied to the system board. You
must disconnect the power cord from the power source before
opening the computer to prevent system board or component
damage.

Basic Troubleshooting

This section concentrates on problems that you might encounter
during the initial set up process. A comprehensive
Troubleshooting Guide is available on the Documentation CD
and online at
and language, select See support and troubleshooting
information, enter the model number of the computer, and press
Enter.

Solving General Problems

You may be able to easily resolve the general problems described
in this section. If a problem persists and you are unable to resolve
it yourself or if you feel uncomfortable about performing the
operation, contact an authorized dealer or reseller.
Getting Started
http://www.hp.com/support
www.hp.com
Getting Started
"Solving Hardware
for instructions.
. Select your country
11

Advertisement

Table of Contents
loading

Table of Contents