Table of Contents
Advertisement
Jumper setting
Set the jumpers on the DM-D stand as follows:
JP1
JP2
1-2
1-2
Set the jumpers as in the left columns when connecting both the TM
printer and the DM-D stand. (Default setting)
2-3
2-3
Set the jumpers as in the left column when using the DM-D stand as
stand alone. (TM printer is not connected.)
The jumpers are located as follows:
JP2
Precautions on using the power supply unit
To avoid damage to the DM-D210 and the power supply unit, make
sure to note the following points.
Use the optional Seiko Epson products, PS-170, or PA-6508,
PA-6511, PA-6513, PB-6509 or PB-6510 as the power supply.
Never connect the DC cable to the power supply unit when the
power supply unit is connected.
Unplug the DC cable by holding the connector part. If you pull the
cable to unplug, it may be damaged.
Contents
JP1
25
Advertisement
Table of Contents
