Pairing With Bluetooth - Cisco Board Series User Manual

Introduction
Pairing with Bluetooth®
You can use Bluetooth connection to pair external devices
such as your phone or laptop, with your Cisco device. You can
also pair headsets - see the next page.
You can switch between the speaker on the Cisco device and
the devices connected through Bluetooth. Select the icon
in the status bar of the user interface, and choose from the
available devices.
NOTE: You can't have both a headset and another Bluetooth
device connected simultaneously.
The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by Cisco is under
license. Other trademarks and trade names are those of their respective owners.
15513.07 Cisco Board and Desk Series User Guide MAY 2025
All contents © 2025 Cisco Systems, Inc. All rights reserved
Pairing devices
NOTE: You can't use Bluetooth to stream music while in a call.
To pair an external device:
1. Open the control panel, tap Device settings
Bluetooth. If Bluetooth is disabled, toggle it on. It's enabled
by default.
2. Toggle on Discoverable. You only need to set the Cisco
device as discoverable when you connect a new device.
The Cisco device goes automatically out of discoverable
mode after five minutes.
3. Go to the Bluetooth settings on your external device and
scan for available devices.
4. Select your Cisco device from the devices list and pairing
begins. It may take a few seconds for the pairing to
complete.
5. If the pairing is successful, your device is listed as
connected. The pairing is completed.
Icon appears here. Tap it to
change between Cisco device
speakers and another device.
Speakers
Analog headset
USB headset
USB handset
Bluetooth device
and scroll to
12