Connecting The Power Cord (1) - Pioneer TS-A1072R - Car Speaker - 20 Watt Installation Manual

Connecting the System

Connecting the power cord (1)

Speed detection circuit lead
Car injection computer
Note: The position of the speed
detection circuit depends on the car
model. For details, consult the rele-
vant documents from Pioneer.
When making connections for a
model not listed in those docu-
ments or for which connection to
the speed detection circuit is too
difficult, connect the separately
sold ND-PG1 speed pulse genera-
tor to the pink lead.
Note: The position of the parking
brake switch depends on the car
model. For details, consult the car
owner's manual or dealer.
Connection method
11
Connector
Pink (CAR SPEED SIGNAL INPUT)
The navigation system is connected here to detect the distance the
car travels. Always connect the car's speed detection circuit or the
ND-PG1 speed pulse generator, sold separately. Failure to make
this connection will increase in the location display.
WARNING: IMPROPER CONNECTION MAY RESULT IN
SERIOUS DAMAGE OR INJURY INCLUDING ELE-
CRICAL SHOCK, AND INTERFERENCE WITH THE
OPERATION OF THE CAR'S ANTILOCK BRAKING SYS-
TEM, AUTOMATIC TRANSMISSION AND SPEEDMETER
INDICATION.
Lightgreen
Used to detect the ON/OFF status of the parking brake. This lead
must be connected to the power supply side of the parking brake
switch. If this connection is made incorrectly or omitted, cer-
tain functions of your navigation system will be unusable.
Clamp the parking brake
switch power supply side
lead.
Clamp firmly with
needle-nosed pliers.
Connection method
Pass the extension cord
and the lead for the
speed detection circuit
through this hole.
Clamp firmly with
needle-nosed pliers.
Close the cover.
Power supply side
Ground side
Parking brake switch