Related Manuals for Portwell WEBS-89I0
Summary of Contents for Portwell WEBS-89I0
- Page 1 WEBS-89I0 User's Manual Copyright © Portwell, Inc., 2023. All rights reserved. All other brand names are registered trademarks of their respective owners.
- Page 2 Quick Guide for WEBS-89I0 You will find the specifications, interface definition and how to use the product from this quick guide. Please read and learn this guide carefully before power on, for the I/O development Kit, please contact sales or local reseller.
-
Page 3: Specification
Product information 2.1 Specification Model Name WEBS-89I0 Intel ®Celeron J6412,2.0-2.6GHz, 4 Cores,4 Threads，1.5MB L2 Cache BIOS AMI UEFI 256Mbit 1 x SO-DIMM DDR4-3200MHz, Memory Support up to 32GB 1 x M.2-2242 M key SSD Slot， Storage SATA3.0 3 x USB3.1... -
Page 4: Interface Specifications
Product information 2.2 Interface specifications 2.3 Interface description... - Page 5 Product information...
- Page 6 2.5 Connection and use 2.5.1 Phoenix terminal wiring The power input interface and serial communication interface of WEBS-89I0 adopt spring-type pressing terminals. Please connect according to the parameters in the table when using, otherwise it may lead to loose wiring, falling off or unstable communication.
-
Page 7: Power Supply
Product information 2.5.3 RS-485 communications The WEBS-89I0 have 1 channel of RS-485 with phoenix terminal. The cable is recommended to use a shielded twisted pair and the shield should be connected to the ground properly by the single point. A120 ohm terminal resistor should be placed at the end of the cable for limiting bus reflections. -
Page 8: Memory Card Installation
Product installation 2.5.5 Memory card installation Use a hexagonal screwdriver to remove the four screws (position 1-4 in Figure 1), open the rear case (position 5 in Figure 1), and insert the memory card into the slot(position 6 in Figure 1) at an angle of 30°, then press it in the direction of the arrow (Figure 1) until the card audibly latches into place. -
Page 9: Sim Card Installation
WEBS-89I0 support wall mounted in default, and DIN-rail mounted is an option. 2.6.1 Ground wiring WEBS-89I0 have a ground screw on the side of the power terminal, it is recommended to use thicker and shorter cable to connect to the ground nearby properly. -
Page 10: Wall Mounted Installation
8mm and greater than 4.5mm, screw length not less than 8mm. 2.6.4 DIN-Rail mounted installation WEBS-89I0 also support DIN-Rail mounted as an option. Put the IPC in the normal mounting position, the IPC is mounted on the DIN rail from above. Make sure that the universal DIN rail adapter is in the correct position behind the DIN rail (A in Figure 1).
Need help?
Do you have a question about the WEBS-89I0 and is the answer not in the manual?
Questions and answers