Filter Assembly - Craftsman 17776 - Clean N Carry 4 Gal. Wet-Dry VAC Owner's Manual

Filter Assembly
1, Carefully slide the filter over the filter
cage, sliding it over the center ring
covering the 3 slots until the filter stops
against the lid.
2, Place the hole in the filter plate over the
threaded screw of the filter cage,
3, Gently push on the filter plate to seat the
rubber ring of the filter inside the circular
channel of the filter plate,
4, Place the filter nut onto the threaded
screw and tighten it down, Finger
tighten only.
NOTE: Lever of filter nut should be away
from plate as shown,
mMPORTANT: Do not over tighten as this
may deform or crack the filter cage or filter
plate.
5, To assemble the power head to the
drum, position power head over drum,
with laches lined up with recess in drum.
(The power head will only fit on the
drum one way).
6, Rotate both latches down and press
until you hear them snap over the
flanges on the drum,
7, Your Portable Wet/Dry Vac is now ready
to use. Read the instructions on the
following pages to operate your
Portable Vac safely.
NOTE: Your filter has a purple stripe that
matches an in-store displayer. When you
visit your local Sears store, just remember
the color of your stripe for the correct size
filter,
ilter Nut
- Filter Plate
Fitter
Latch (2) lge
Head
Drum