Connecting The Power Cord; Power Saving; Display Data Channel (Ddc); Freesync Premium (Hdmi / Dp / Type C) - Acer Spatiallabs View Pro 27 Asv27-2P User Manual

Connecting the power cord

• Check first to make sure that the power cord you use is the correct
type required for your area.
• The monitor has a universal power supply that allows operation in either
100/120 V AC or 220/240 V AC voltage area. No user-adjustment is
required.
• Plug one end of the power cord to the AC inlet, and plug the other end into
an AC outlet.
• For units using 120 V AC:
Use a plug rated 4.74 A/125 V.
• For units using 220/240 V AC:
Use a plug rated 4.74 A/220 V. The cord set should have the appropriate safety
approvals for the country in which the equipment will be installed.

Power saving

The monitor will be put into "power saving" mode if the monitor does not detect
any input signals for about one minute, as indicated by the amber power LED.
Mode
On
Power saving
Off
The power saving mode will be kept until an input signal has been detected or the
keyboard or mouse is activated. The recovery time from "power saving" mode
back to "on" is around 3 seconds (Auto Source off).

Display Data Channel (DDC)

To make installation easier, the monitor supports plug-and-play
functionality as long as your system is compatible with the DDC protocol.
The DDC is a communication protocol through which the monitor
automatically informs the host system about its capabilities, such as
supported resolutions and corresponding timing. The monitor supports the
DDC2B standard.

FreeSync Premium (HDMI / DP / Type C)

The monitor allows a FreeSync Premium supported graphics source to dynamically
adjust display refresh rate based on typical content frame rates for power
efficient, virtually stutter free and low-latency display update.
8
LED light
Blue
Amber
Off