Delta 36-714 Instruction Manual page 20
10" hybrid saw
Hide thumbs
Also See for 36-714:
- Instruction manual (80 pages) ,
- Instruction manual (88 pages) ,
- Instruction manual (96 pages)
Table of Contents
Advertisement
ADJUSTING BLADE ALIGNMENT
BLADE ALIGNMENT IS FACTORY SET
AND
SHOULD
NOT
NEED
ADJUSTMENT. ADJUSTING BLADE ALIGNMENT IN
THE FIELD IS A DIFFICULT AND TIME-CONSUMING
PROCEDURE. ALL SAW BLADES HAVE SOME RUN-
OUT.
THEREFORE,
RE-ADJUSTING
BLADE
ALIGNMENT SHOULD ONLY BE ATTEMPTED IF IT
BECOMES NECESSARY. (SEE CHECKING BLADE
ALIGNMENT.)
DISCONNECT
MACHINE
FROM
POWER SOURCE.
1. Lower blade. Remove blade guard and table insert.
With a 1/2″ wrench, slightly loosen the 4 front and
rear trunnion mounting bolts. NOTE: Two trunnion
mounting bolts (E) Fig. 37 are shown as looking up
inside side of saw.
2. Move the trunnion assembly in the desired direction.
Tap gently with rubber mallet if necessary.
3. To
check
blade
alignment,
follow
section
“CHECKING BLADE ALIGNMENT” procedure until
proper alignment is achieved. Tighten 4 trunnion
bolts (E) Fig. 37.
4. Check blade alignment again after tightening bolts to
confirm alignment. If alignment is off, loosen the 4
trunnion bolts (E) and repeat the above steps until
proper alignment is achieved with bolts fully
tightened.
5. Install table insert, blade guard, and lower blade
before reconnecting power source.
BACKLASH ADJUSTMENTS
DISCONNECT
MACHINE
FROM
POWER SOURCE.
After a period of extended use, if any play is detected in
the blade raising or blade tilting mechanisms, remove
the blade and make the following adjustments:
ADJUSTING BLADE RAISING MECHANISM - Loosen
locknut (A) Fig. 38, and turn eccentric sleeve (B) until all
play is removed. Tighten locknut (A) while holding
sleeve in place.
ADJUSTING BLADE TILTING MECHANISM - Loosen
locknut (C) Fig. 38, and turn eccentric sleeve (D) until all
play is removed. Tighten locknut (C) while holding
sleeve in place.
E
Fig. 37
C
D
B
A
Fig. 38
Page 20
Hide quick links:
Advertisement
Table of Contents
