Table of Contents
Advertisement
,&
,&
WARNING:
When servicing, use only identical
Craftsman replacement
parts. Use of any other parts
may create a hazard or cause product damage.
WARNING:
Always wear safety goggles or safety
glasses with side shields during power tool operation
or when blowing dust. If operation is dusty, also wear
a dust mask.
GENERAL
MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use.
Use clean cloths to remove dirt, dust, oil, grease, etc.
A
WARNING:
Do not at any time let brake fluids,
gasoline, petroleum-based
products, penetrating
oils, etc., come in contact with plastic parts. Chemi-
cals can damage, weaken or destroy plastic which
may result in serious personal injury.
Electric tools used on fiberglass material, wallboard,
spackling compounds,
or plaster are subject to accel-
erated wear and possible premature failure because the
fiberglass chips and grindings are highly abrasive to bear-
ings, brushes, commutators,
etc. Consequently, we do not
recommended
using this tool for extended work on these
types of materials. However, if you do work with any of
these materials, it is extremely important to clean the tool
using compressed air.
LUBRICATION
All of the bearings in this tool are lubricated with a suffi-
cient amount of high grade lubricant for the life of the unit
under normal operating conditions. Therefore, no further
lubrication is required.
Only the parts shown on the parts list are intended to be
repaired or replaced by the customer. All other parts
should be replaced at a Sears Service Center.
BLADE REPLACEMENT
See Figures 24-26.
After extended use, the blade may become dull. If you
accidentally hit a nail or other blunt object, it will dull or
break the blade. These situations require replacing the
blade.
REPLACING
THE BLADE
Unplug the tool.
Place the biscuit joiner upside down on a workbench
and remove the bottom shoe screws (4) and bottom
shoe.
i
I
SCREWS(4)
i
I
I
I
I
BOTTOM
SHOE
Fig. 24
•
Place a Phillips screwdriver or 3/16 in. diameter pin
between the blade and front base.
•
Place one of the blade teeth against the screwdriver or
pin and lock blade preventing it from rotating,
PHILLIPSSCREWDRIVER
OR3/16 IN. DIAMETER PIN
BLADE
FRONTBASE
Fig. 25
20
Hide quick links:
Advertisement
Table of Contents
