Craftsman 11483 - C3 19.2 Volt Impact Driver Operator's Manual page 11

BIT STORAGE
See Figure 6.
When not in use, bits provided with the tool can be placed
in the storage area located at the bottom of the tool handle.
(
SCREWDRIVER
BiTS
INSTALLING THE MAGNETIC BIT HOLDER AND
DRILL BIT OR SOCKET ADAPTOR
See Figure 8.
[] Lock the switch trigger by placing the direction of
rotation selector in the center position.
[] Pull the coupler forward and hold in position.
[] insert magnetic bit holder straight into coupler as
shown.
[] Slide the coupler back slowly and release.
[] insert drill bit or socket adaptor straight into bit holder
as shown.
RELEASE COUPLER
BIT STORAGE AREA Fig. 6
INSTALLING BITS
See Figure 7.
[] Lock the switch trigger by placing the direction of
rotation selector in the center position.
[] Pull the coupler forward and hold in position.
[] Insert bit straight into coupler as shown.
[] Slide the coupler back slowly and release.
RELEASE COUPLER
LOCKING GROOVE
REMOVING BITS
See Figure 7.
[] Lock the switch trigger by placing the direction of
rotation selector in the center position.
[] Pull the coupler forward and hold in position.
[] Pull bit straight out of coupler.
/
Fig. 7
PULLCOUPLER Q,_
FORWARD
MAGNETIC
BIT HOLDER INSERTBIT
LOCKING GROOVE
1/4 in. SOCKET ADAPTER
COUPLER
Fig. 8
REMOVING THE MAGNETIC BIT HOLDER AND
DRILL BIT OR SOCKET ADAPTOR
See Figure 8.
[] Pull drill bit or socket adaptor straight out of bit holder.
[] Lock the switch trigger by placing the direction of
rotation selector in the center position.
[] Pull the coupler forward and hold in position.
[] Pull magnetic bit holder straight out of coupler.
11