3onedata Logicbus CP202-2CI-P Quick Installation Manual

CP202-2CI-P (12-48VDC)
CAN Server
Quick Installation Guide
3onedata Co., Ltd.
Address: 3/B, Zone 1, Baiwangxin High Technology
Industrial Park, Xili, Nanshan District,
Shenzhen
Website: www.3onedata.com
Tel: +86 0755-26702688
Fax: +86 0755-26703485
Package Checklist
Please check the integrity of package and accessories while
first using the CAN server.
1. CAN server X1 (with wiring terminal block)
2. Straight-through network cable
3. Wall mounting accessories
4. Power adapter
5. Warranty card
6. Certification
If any of these items are damaged or lost, please contact our
company or dealers, we will solve it ASAP.
Products Overview
This product is a CAN server, the model is CP202-2CI-P (12-
48VDC) (2 CAN bus ports to 1 10/100 Base T(X) converter).
Panel Design
Top view, main view and bottom view
1. Terminal block for power input
2. Restoring factory setting button Setup
3. 100M Ethernet RJ45 port
4. Indicators, from top to bottom in turn they are:
- Power indicator PWR
- system running indicator RUN
- network link indicator LINK
- CAN port error indicator ERR1
- CAN port state indicator CAN1
- CAN port error indicator ERR2
- CAN port state indicator CAN2
Lugs
5.
CAN0/terminal block
6.
7. CAN1/terminal block
8. DIP switch
Mounting Dimension
Unit: mm
Notice Before Mounting:
Don't place or install the device in area near water or moist,
keep the relative humidity of the device surrounding
between 5%~95% without condensation.
Before power on, first confirm the supported power supply
specification to avoid over-voltage damaging the device.
Wall-mounted Device Mounting
Step 1 Place the CAN server on the wall as reference or
reference installation dimension; label the bolt
position on the wall.
Nail M4 screws on the wall and keep 2mm
Step 2
interspace reserved.
Hang the device on two screws and slide
Step 3
downward, then tighten the screw to enhance
stability, mounting ends.