Black & Decker BXEFC60E Instructions For Use Manual page 5

DESCRIPTION
A Ceiling bracket
B Body
C Remote control
D Remote control support
REMOTE CONTROL
1 Speed selector (1/2/3/4/5/6)
2 On/off button
3 Rotation direction change
4 Timer 1/2/4/8 hours
5 Light
6 Airflow mode button
USE AND CARE
• Do not use the appliance if the on/off button does not
work.
INSTRUCTIONS FOR USE
BEFORE USE
• To reduce the risk of electric shock, ensure electricity has
been turned off at the circuit breaker or fuse box before
beginning.
• All wiring must be in accordance with the national and
local electrical codes. Electrical installation should be
performed by a qualified electrician.
• Be sure to remove all packaging material from inside the
appliance.
FAN INSTALLATION
• See "FAN INSTALLATION" at the beginning of the instruc-
tion manual. (Steps 1-6).
• This fan can be mounted on a regular (no-slope) or
vaulted ceiling. Other installations, such as a flush mount,
are not available for this fan.
• IMPORTANT: In the package, you will find the screws and
plugs for fixing the bracket to the ceiling (conventional
ceiling). This material may not be suitable depending on
the type of ceiling , such as plasterboard ceiling. If any
doubts, ask a professional.
• Ensure the electricity has been turned off at the circuit
breaker or fuse box before any installation or assembly
operation.
• Take the product out of the packaging. To avoid damaging
the housing surfaces, place the product on a soft surface.
• In order to avoid electric shock, make sure that the power
supply has been previously disconnected.
• The electrical installation must be done in accordance
with national regulations.
• It is recommended that the installation be done by a
professional.
• Install the fan at a minimum distance of 2,30 meters from
the ground or other objects.
• The light of the fan can be connected in two ways. One
way is to control the fan and the light through the remote
control (See wiring diagram). The other is to control the
light through the wall switch and the fan through the
remote control. This change must be made by a licensed
electrician.
ASSEMBLING THE BATTERIES OF THE REMOTE
CONTROL
• Caution: During the handling of batteries, do not touch
both poles at the same time, as this will provoke the
partial discharge of the stocked energy, therefore, affect-
ing longevity.
• Remove the cover of the battery compartment.
• Check that the plastic covering that protects the battery
has been removed (some batteries are sold with a protec-
tive covering).
• Fit the batteries, ensuring the correct polarity as indicated
in the battery compartment. The batteries have to be 1,5
V AAA.
• Replace the cover of the battery compartment.
• Do not mix new and used batteries
• Non-rechargeable batteries are not to be recharged
• Rechargeable batteries are to be removed from the
product before being charged
• Exhausted batteries should be removed and safely dis-
posed of
• The supply terminals should not be short-circuited
• It is essential that the batteries should always be the
same kind and have the same charge. Never mix alkaline
batteries with Carbon-Zinc ones and/or rechargeable
ones.
• Remove the batteries from the remote control if you are
not going to use it for some time. If the battery is left in the
device for too long when it's not used, there is a risk of
leakage. If that happens, avoid any contact with the liquid,
as it can cause chemical burns. If contact accidentally
occurs, flush with water. If liquid contacts the eyes, addi-
tionally seek medical help.
5