16-44 ELECTRICAL SYSTEM
Ignition System
Stick Coil Removal
Never drop the stick coils, especially on a hard sur-
face.
Such a shock to the stick coils can damage it.
•
Remove the fuel tank (see Fuel Tank Removal in the Fuel
System (DFI) chapter).
•
Disconnect the stick coil connector and pull the stick coil
#4 [A] off the spark plug.
Do not pry the connector part of the coil while re-
moving the coil.
•
Remove:
Bolt [B] (for Stick Coil #2 and #3)
Stick Coil Harness Connector [C] with Bracket and Bolt
(for Stick Coil #3)
•
Disconnect the stick coil connector and pull the stick coil
#3 [A] off the spark plug.
○
Take out the stick coil #3 from between the frame and
thermostat housing.
•
Remove the air switching valve hose [A] (for Stick Coil
#2).
•
Disconnect the stick coil connectors [B].
•
Pull the stick coil #1 [C] and #2 off the spark plugs.
Stick Coil Installation
•
Insert the coil as shown being careful of the coil heads [A]
direction.
•
Be sure the stick coils are installed by pulling up it lightly.
•
Connect the connectors.
Do not tap the coil head while installing the coil.
•
Run the hoses and harness correctly (see Cable, Wire,
and Hose Routing section in the Appendix chapter).
•
Install the removed parts (see appropriate chapters).
CAUTION
CAUTION
CAUTION
Comments to this Manuals
Latest comments: