Slide in the fuse box [A] into the front seat bracket [B] until
the stopper [C] fits in the bracket.
Run the seat lock cable [A] under the front seat bracket
[B] and then install the bracket.
Tighten the left side bolts [C] of the front seat bracket first.
Confirm that the clamp [D] for the front seat lock cables
[E] is in the front seat bracket.
Make sure that the model name [A] of the electrolyte con-
tainer matches the model name [B] of the battery. These
names must be the same.
Battery Model Name for ZR750L/M: YTX9-BS
Be sure to use the electrolyte container with the
same model name as the battery since the elec-
trolyte volume and specific gravity vary with the
battery type. This is to prevent overfilling of the
electrolyte, shorting the battery life, and deteriora-
tion of the battery performance.
Do not remove the aluminum sealing sheet [A] from
the filler ports [B] until just prior to use. Be sure to
use the dedicated electrolyte container for correct
Place the battery on a level surface.
Check to see that the sealing sheet has no peeling, tears,
or holes in it.
Remove the sealing sheet.
The battery is vacuum sealed. If the sealing sheet has
leaked air into the battery, it may require a longer initial
ELECTRICAL SYSTEM 16-23