Front Fender Removal
Brake Hose Clamps [A] (Both Sides)
Bolts [B] with Washers (Both Sides)
Front Fender [C]
Front Fender Installation
Install the front fender to the front fork.
Torque - Front Fender Bolts: 3.9 N·m (0.40 kgf·m, 35 in·lb)
Install the brake hose clamps to the front fender holes.
Flap and Rear Fender Removal
Seats (see Rear/Front Seat Removal)
Seat Covers (see Seat Cover Removal)
Exhaust Butterfly Valve Actuator Mounting Bolts (see
Exhaust Butterfly Valve Actuator Removal in the Fuel
System (DFI) chapter)
Owner's Tool [A]
Relay Box [B] (see Relay Box Removal in the Electrical
ECU (see ECU Removal in the Fuel System (DFI) chap-
Battery [C] (see Battery Removal in the Electrical Sys-
Vehicle-down Sensor [D] (see Vehicle-down Sensor Re-
moval in the Fuel System (DFI) chapter)
Starter Relay [E] (see Starter Relay Inspection in the
Electrical System chapter)
Fuse Box [F]
Flap (see Seat Cover Removal)
Remove the bolts [A].
Pull out the rear fender [B] backward.
Flap and Rear Fender Installation
Installation is the reverse of removal.
Install the removed parts (see appropriate chapters).
Run the cables, leads, harness and hose correctly (see
Cable, Wire, and Hose Routing section in the Appendix