Settle the bearings in place as follows.
Tighten the steering stem nut with 55 N·m (5.6 kgf·m, 41
ft·lb) of torque first, and loosen it a fraction of a turn until
it turns lightly. Afterward tighten it again with specified
torque using a steering stem nut wrench [A].
Special Tool - Steering Stem Nut Wrench: 57001-1100
Torque - Steering Stem Nut: 27 N·m (2.8 kgf·m, 20 ft·lb)
Install the claw washer [A] so that its bent side [B] faces
upward, and engage the bent claws with the grooves of
stem locknut [C].
Hand tighten the stem locknut until it touches the claw
Tighten the stem locknut clockwise until the claws are
aligned with the grooves (ranging from 2nd to 4th) of stem
nut [D], and bend the 2 claws downward [E].
Install the stem head.
Install the washer, and temporary tighten the steering
stem head bolt.
Install the front forks (see Front Fork Installation in the
Tighten the upper front fork clamp bolts first, next the
stem head bolt, last the lower front fork clamp bolts.
Tighten the two front fork clamp bolts alternately two
times to ensure even tightening torque.
Torque - Upper Front Fork Clamp Bolts: 20 N·m (2.0 kgf·m,
Steering Stem Head Bolt: 108 N·m (11.0 kgf·m,
Lower Front Fork Clamp Bolts: 21 N·m (2.1 kgf·m,
Do not impede the handlebar turning by routing the
cables, harnesses and hoses improperly (see Ca-
ble, Wire, and Hose Routing section in the Appen-
Install the removed parts (see appropriate chapters).
Steering Stem Bearing Lubrication
Refer to the Steering Stem Bearing Lubrication in the Pe-
riodic Maintenance chapter.