Tie-Rod, Rocker Arm
Tie-Rod and Rocker Arm Bearing Removal
Tie-Rods (see Tie-Rod Removal)
Rocker Arm (see Rocker Arm Removal)
Oil Seals [B]
Swingarm [C] (see Swingarm Removal)
Remove the needle bearings [D], using the bearing re-
mover head and bearing remover shaft.
Special Tools - Bearing Remover Head,
Bearing Remover Shaft, 13: 57001-1377
Tie-Rod and Rocker Arm Bearing Installation
Replace the needle bearings and oil seals with new ones.
Apply plenty of grease to the lips of the oil seals.
Install the needle bearings and oil seals position as shown
in the figure.
Screw the needle bearing driver [A] into the driver holder
Insert the needle bearing driver into the needle bearing
[C] and press the needle bearing into the housing until
the driver contacts the end surface of the housing.
Bearing Pressing Depth: 5.5 mm (0.22 in.) [D]
5.0 mm (0.20 in.) [E]
For a bearing of inner diameter 18, select the pressing
side of the needle bearing driver according to its press-
Special Tools - Bearing Driver Set: 57001-1129
Needle Bearing Driver,
Spacer, 18 [F]: 57001-1636