Anti-Lock Brake System (Equipped Models)
Do the 4th step test.
Check the battery terminal voltage between the red lead
terminal of the fuse box [A] and ground.
Special Tool - Hand Tester: 57001-1394
Battery Terminal Voltage
If the battery terminal voltage is not within the specifica-
tion, 5th step.
If the battery terminal voltage correct, 6th step.
Do the 5th step test.
Check for continuity between the positive cable [A] of the
battery and red lead terminal of the main harness side
If there is the continuity in the lead, 4th step.
If there is not the continuity in the lead, replace or repair
the main harness.
Do the 6th step test.
Recheck the service code indication; erase the service
code, perform the pre-diagnosis inspection 1 and 2, and
retrieve the service code.
If the ABS indicator light (LED) [A] lit, faulty ABS pump
motor relay in the ABS hydraulic unit. Replace the ABS
If the ABS indicator light (LED) unlit, ABS system is nor-
mal (service code is not stored; temporary failure.).
Front Wheel Rotation Sensor Signal Abnormal
(Service Code 42)
Do the 1st step test.
Measure the air gap between the front wheel rotation sen-
sor and sensor rotor.
Thickness Gauge [A]
If the measurement is over standard, check each part
for deformation and looseness and correct accordingly.
Recheck the air gap.
If the measurement is correct, 2nd step.
0.9 mm (0.028