Stretch the open cable (white) by using the adjuster [A].
Turn the adjuster counterclockwise until it becomes hard
Locknut of White [B]
Do not overstretch. If the adjustment of the exhaust
butterfly valve cables are incorrect, the exhaust but-
terfly valve actuator does not operate correctly.
Torque - Exhaust Butterfly Valve Cable Adjuster Locknuts:
6.9 N·m (0.70 kgf·m, 61 in·lb)
Cover the dust covers [C].
Be sure that the dust covers [D] are in positions as shown.
Turn the ignition switch ON, and confirm the pulley turns
counterclockwise and then clockwise.
If the operation of the pulley is different, readjust the ex-
haust butterfly valve cables.
Confirm the pulley is original position.
If the pulley is no original position, adjust the pulley (see
Exhaust Butterfly Valve Actuator Installation in the Fuel
System (DFI) chapter).
Confirm the operation of the pulley as follows.
Start the engine, and confirm the pulley turns clockwise
and then it stops.
Open the throttle, and confirm the pulley turns counter-
If the pulley does not operate, readjust the exhaust but-
terfly valve cables.
Install the removed parts (see appropriate chapters).
ENGINE TOP END 5-43