3-76 FUEL SYSTEM (DFI)
Subthrottle Sensor (Service Code 32)
Measure the output voltage with the engine stopped with
the connector joined.
Turn the ignition switch ON.
Measure the output voltage when the subthrottle valve is
completely closed by turning the lever [A] fully clockwise
Turn the lever counterclockwise, confirm the output volt-
age will be raise.
The standard voltage refers to the value when the volt-
age reading at the Input Voltage Inspection shows 5 V
When the input voltage reading shows other than 5 V,
derive a voltage range as follows.
In the case of a input voltage of 4.75 V.
0.48 × 4.75 ÷ 5.00 = 0.46 V
0.52 × 4.75 ÷ 5.00 = 0.49 V
Thus, the valid range is 0.46
If the reading is out of the standard, check the subthrot-
tle sensor resistance (see Subthrottle Sensor Resistance
If the reading is within the standard, remove the ECU and
check the wiring for continuity between main harness side
Disconnect the ECU and sensor connectors.
ECU Connector [A] ←→
Subthrottle Sensor Connector [B]
BR lead (ECU terminal 24) [C]
BR/BK lead (ECU terminal 28) [D]
If the wiring is good, check the ECU for its ground and
power supply (see ECU Power Supply Inspection).
If the ground and power supply are good, replace the ECU
(see ECU Removal/Installation).
Subthrottle Sensor Resistance Inspection
Turn the ignition switch OFF.
Disconnect the subthrottle sensor connector.
Connect a digital meter [A] to the subthrottle sensor con-
Measure the subthrottle sensor resistance.
Subthrottle Sensor Resistance
Connections: BL lead [C] ←→ BR/BK lead [D]
If the reading is out of the standard, replace the throttle
If the reading is within the standard, but the problem still
exists, replace the ECU (see ECU Removal/Installation).
0.52 V at idle throttle opening
4.0 V at full throttle opening (for