16-84 ELECTRICAL SYSTEM
Switch and Sensors
Fuel Reserve Switch Inspection
Fill the fuel tank with fuel.
Close the fuel tank cap surely.
Seat (see Frame chapter)
Fuel Pump Connector (see Fuel System chapter)
Connect the test light (12 V 3.4 W bulb a socket with wires)
[B] and 12 V battery and the 12 V battery [A] to the fuel
pump connector [C].
Battery (+) → 12 V 3.4 W Bulb (one side)
12 V 3.4 W Bulb (other side) → R/BK Wire Terminal
Battery (−) → BK/Y Wire Terminal
If the test light turn on, the reserve switch is defective.
Fuel Pump (see Fuel System chapter)
Connect the test light (12 V 3.4 W bulb in a socket with
wires) and the 12 V battery to the fuel pump connector as
12 V Battery [A]
Test Light [B]
Fuel Pump Connector [C]
Fuel Reserve Switch [D]
If the test light doesn't light, replace the fuel pump.
It may take a long time to turn on the test light in case
that the fuel reserve switch is inspected just after the
fuel pump is removed.
Leave the fuel reserve switch with leads for inspection
connected for one (1) minute.
Speed Sensor Removal
Alternator Outer Cover (see this chapter)
Speed Sensor Lead Connector [A]
Speed Sensor [D]
Speed Sensor Installation
Apply grease to the O-ring [A] on the speed sensor.
Non-permanent Locking Agent -
Speed Sensor Mounting Bolt
Torque - Speed Sensor Mounting Bolt: 9.8 N·m (1.0 kgf·m,