16-76 ELECTRICAL SYSTEM
Meter, Gauge
•
Using the auxiliary wires, connect a 12 V battery to the
meter unit connector terminals.
First Connections:
Battery Positive Terminal (+) → Terminal [7]
Battery Negative Terminal (−) → Terminal [3]
Next Connections:
Battery Positive Terminal (+) → Terminal [1]
•
Verify that all the LCD segments (the letters and numbers
of the liquid crystal display) to appear for 3 seconds. Then
the clock or meters normally depending on the mode se-
lected.
•
Check that disconnect the terminal [1] causes all the LCD
segments to become unlit.
If there is any problem, replace the digital meter assembly.
Speedometer Inspection:
•
If an oscillator is unavailable, check the speedometer as
follows.
○
Connect the meter harness connectors [A].
○
Use the jack and the attachment jack to lift the rear wheel.
Special Tools - Jack: 57001–1238
Attachment Jack: 57001–1398
○
Set the hand tester to the DC 10 V range, check the
voltage between the LG/R wire terminal and ground as
shown.
Connections:
Hand Tester (+) → LG/R Wire Terminal
Hand Tester (−) → Ground
Special Tool - Hand Tester: 57001–1394
○
Squeeze the clutch lever, and hold it with a band.
○
Shift the gear position to the 1st position.
○
Turn the ignition switch ON, and slowly rotating the rear
wheel.
○
At this time, the tester's pointer should swing 0 V and 5 V.
If the tester's pointer does not swing 0 V and 5 V, inspect
the speed sensor.
If the tester's pointer does swing 0 V and 5 V, replace the
digital meter assembly.
Comments to this Manuals
Latest comments: