16-74 ELECTRICAL SYSTEM
Meter Unit Assembly
Connect the connectors of the meter harness.
Put on the rubber lid [A] on the lower cover [B].
Tighten the screw together with the harness clamp [C] as
Meter Unit Inspection
Mode Select and Reset Button Checks:
When the ignition switch is turned ON, all the LCD seg-
ments (the letters and numbers of the liquid crystal dis-
play) [A] appear for 3 seconds on the meter.
If they do not appear, check the LCD segments.
Check that the display [B] changes to the ODO, TRIP, and
CLOCK displays each time the mode select button [A] is
If the display doesn't change in the order specified, re-
place the digital meter assembly.
Push the mode select button to TRIP and push the reset
button [A] more than 2 seconds. The display shows "0.0".
If the display doesn't show "0.0", replace the digital meter
Push the mode select button to CLOCK.
Push the reset button [A] more than 2 seconds enables
the display to assume the HOUR/MINUTE setting mode
In the HOUR/MINUTE setting mode, the numbers flashes
on the display.
Check that the flashing number changes to the
HOUR/MINUTE, HOUR and MINUTE displays each
time the reset button is pushed.
Check that the time can be set in this mode.
If the time cannot be set, replace the digital meter assem-