Oil Pressure Warning System
Oil Pressure Light Delay Unit Removal
Remove the right side cover (see Frame chapter).
Remove the coolant reserve tank bolts and hanging the
reserve tank [A].
Pull the connectors out of the oil pressure light delay unit
Oil Pressure Light Delay Unit Inspection
Disconnect the wire [A] of the oil pressure switch [B] and
ground [C] it to the engine, using an auxiliary wire.
Turn the ignition switch [D] ON.
If the oil pressure warning LED light [E] is lit, replace the
oil pressure switch.
If the warning LED light is not lit, check the warning LED
light bulb and wiring (see Meter Unit Inspection).
If the LED light and wiring are good, replace the oil pres-
sure light delay unit [F].
Turn the ignition switch ON.
Ground the oil pressure switch wire to the engine, then the
oil pressure warning LED light should be lit with a delay.
Measure this delay time from grounding of the switch wire
to lighting of the warning LED light.
Lighting Delay Time
about 3 seconds
If the lighting delay time is out of the standard too far,
replace the oil pressure light delay unit.
ELECTRICAL SYSTEM 16-71