Periodic Maintenance Procedures
If it does not, adjust the brake light switch.
•
While holding the switch body, turn the adjusting nut to
adjust the switch.
Switch Body [A]
Adjusting Nut [B]
Light sooner as the body rises [C]
Light later as the body lowers [D]
To avoid damaging the electrical connections in-
side the switch, be sure that the switch body does
not turn during adjustment.
Suspension
Front Fork Oil Leak Inspection
•
Visually inspect the front forks [A] for oil leakage, scoring
or scratches on the outer surface of the inner tubes.
Replace or repair any defective parts, if necessary.
Rear Shock Absorber Oil Leak Inspection
•
Visually inspect the shock absorbers [A] for oil leakage.
If they are oil leaked, one unit feels weaker than the other,
replace both shock absorber as a set.
Swingarm Pivot Lubrication
•
Remove the swingarm (see Suspension chapter).
•
Clean the old grease out of the bearings.
•
Apply grease to the inner surface of the needle bearings
[A].
•
Apply a thin coat of grease to the lips [B] of the grease
seals.
•
Install the swingarm (see Suspension chapter).
CAUTION
PERIODIC MAINTENANCE 2-31
Comments to this Manuals
Latest comments: