16-66 ELECTRICAL SYSTEM
Automatic Turn Signal Canceling System
Turn Signal Control Relay Inspection
Never drop the turn signal control relay, especially
on a hard surface. Such a shock to the unit can
Remove the right side cover (see Frame chapter).
Connect one 12 V battery and turn signal lights as indi-
cated in the figure, and count how many times the lights
flash for one minute.
Turn Signal Control Relay Connector [A]
Turn Signal Lights [B]
12 V Battery [C]
If the lights do not flash as specified, replace the turn sig-
nal control unit.
Testing Turn Signal Control Relay Inspection
(*): Cycle(s) per minute
(**): corresponds to "one light burned out, and the other
lights stay ON".
Even if the foregoing checks show the turn signal con-
trol relay to be good, it may be defective in some man-
ner especially for automatic turn signal canceling op-
eration not readily detectable with above checks. If all
other checks are good, replace the turn signal control
Turn Signal Light Bulb Replacement
Remove the turn signal light lens screws [A] and take off
the lens [B].
Flashing Times (c/m*)