Open the clamp [A] with (−) screw driver [B].
Remove the regulator/rectifier bolts [A] and take off the
Remove the alternator outer cover (see this chapter).
Disconnect the regulator/rectifier [A] and alternator [B]
Set the hand tester to the × 1 kΩ range and make the
measurements shown in the table.
Special Tool - Hand Tester: 57001-1394
Connect the hand tester to the regulator/rectifier.
If the tester readings are not as specified, replace the
Use only Kawasaki Hand Tester 57001-1394 for this
test. A tester other than the Kawasaki Hand Tester
may show different readings.
If a megger or a meter with a large-capacity battery
is used, the regulator/rectifier will be damaged.
ELECTRICAL SYSTEM 16-37