16-34 ELECTRICAL SYSTEM
Set up the dampers [A] and crankshaft sensor holders [B]
to the pickup coils [C].
Install the crankshaft sensors as shown.
Crankshaft sensor [A] with shorter leads (BK and BK/Y)
for #1 (front)
Crankshaft sensor [B] with longer leads (BK/W and
BK/R) for #2 (rear)
Torque - Crankshaft Sensor Screws: 2.9 N·m (0.30 kgf·m,
Run the longer crankshaft sensor leads over the shorter
crankshaft sensor leads above the alternator leads.
Non-permanent Locking Agent -
Crankshaft Sensor Lead Holder Bolt
Torque - Crankshaft Sensor Lead Holder Bolt: 2.9 N·m
(0.30 kgf·m, 26 in·lb)
Apply silicone sealant to the sides [H] of the grommets as
shown, and fit the grommets into the notch of the alterna-
First, install the grommet [C] for the alternator leads, and
then the grommet [D] for the crankshaft sensor leads with
the round mark [E] up.
Pull [F] the alternator leads and crankshaft sensor leads
[G] outside the alternator cover, and reduce the slack of
leads inside the cover as possible in order to prevent
contact with the rotor.
Apply silicone sealant to the mating surface [I] of the