16-32 ELECTRICAL SYSTEM
Remove the front engine mounting bolt [A].
Loosen the rear engine mounting bolt [B].
Lift up [A] the front part of the engine, using the jack until
the lower part of the alternator inner cover clears the lower
Turn the propeller shaft so that the engine can be raised
as high as possible.
Unscrew the bolts [C] and take off the alternator inner
Alternator Inner Cover Installation
Replace the gasket with a new one.
Install the alternator inner cover.
Torque - Alternator Inner Cover Bolts: 11 N·m (1.1 kgf·m,
Move the engine into its original position and tighten the
engine mounting bolts.
Torque - Engine Mounting Bolts and Nuts: 44 N·m (4.5
kgf·m, 32 ft·lb)
Install the removed parts.
Alternator Rotor Removal
Remove the alternator inner cover (see this chapter).
Hold the alternator rotor [A] steady with the flywheel
holder [B], and remove the rotor bolt [C].
Special Tool - Flywheel Holder: 57001-1410
Take the alternator rotor, washer, and ratchet off the
Alternator Rotor Installation
Install the left balancer [A].
Turn the crankshaft counterclockwise [B] and align the
alignment tooth [C] with the middle of the crankcase rib
[D]. This makes the front piston set to its top dead center.