Steering Stem Installation
Steering Stem [A]
New O-ring [C] (I.D. 34.5 × 2 mm)
Stem Cap [D]
Tighten the stem nut [E] firmly, and loosen it.
Special Tool - Steering Stem Nut Wrench: 57001–1100
Tighten the stem nut again with the specified torque (see
Stem Bearing Installation).
Torque - Steering Stem Nut: 4.9 N·m (0.50 kgf·m, 43 in·lb)
Install the claw washer [F].
Install the fork leg [A] and push [B] it up tightly against the
Temporarily tighten the lower fork clamp bolts [C].
Steering Stem Head [A] with Handlebar
New O-ring [B]
Stem Head Nut [D]
Temporarily tighten the upper fork clamp bolts [E].
Check that the top end [A] of the inner tube is flush with the
upper surface [B] of the steering stem head. Otherwise
reinstall the fork leg.
Tighten the fork upper clamp bolts and then the stem head
nut, and finally the fork lower clamp bolts.
Torque - Fork Upper Clamp Bolts: 29 N·m (3.0 kgf·m, 21
Steering Stem Head Nut: 88 N·m (9.0 kgf·m, 65
Fork Lower Clamp Bolts: 29 N·m (3.0 kgf·m, 21