2-22 PERIODIC MAINTENANCE
Periodic Maintenance Procedures
Clutch Slave Cylinder Piston Seal Replacement
Remove the alternator outer cover (see Electrical System
Loosen the banjo bolt [A] at the clutch pipe lower end, and
tighten it loosely.
Unscrew the slave cylinder bolts [B] and detach the slave
cylinder with the pipe installed from the engine.
Pump the clutch lever until the piston comes out of the
Unscrew the banjo bolt and remove the slave cylinder [C].
Immediately wash away any clutch fluid that spills.
It may damage painted surfaces.
If the clutch slave cylinder is removed and left alone, the
piston will be pushed out by spring force.
Remove the spring and piston seal.
Replace the piston seal with a new one if it was re-
moved from the piston.
Before assembly, apply clutch fluid to the outside of the
piston and the piston seal.
Install the piston seal as shown.
Piston Seal [C]
Engine Lubrication System
Engine Oil Change
Situate the motorcycle so that it is vertical after warming
up the engine.
Remove the engine oil drain plug [A] and drain the oil.