Clutch Master Cylinder [A]
Left Handlebar Switch Housing [B]
Front Brake Master Cylinder [A]
Right Handlebar Switch Housing [B]
Throttle Grip [C]
Unscrew the nuts [A] and remove the handlebar [B] from
the stem head.
Tighten the handlebar nuts.
Torque - Handlebar Nuts: 34 N·m (3.5 kgf·m, 25 ft·lb)
The front half of the right handlebar switch housing [A]
has a small projection [B]. Fit the projection into the small
hole [C] in the handlebar.
Set the left handlebar switch housing [A] to match its mat-
ing surface [B] to the punched mark [C] of the handlebar.
Install the handlebar switch housings.
Clutch Master Cylinder (see Clutch chapter)
Front Brake Master Cylinder (see Brakes chapter)