Front Fork
•
Install:
Spring Seat [A]
Collar [B]
Washer [C]
•
Screw the piston rod nut [D] stopped on to the piston rod.
Left Fork Leg:
•
Install the fork spring [A] with the smaller end facing up-
ward [B].
•
Install:
Washer
Collar
Joint Rod Assy together with the spring
•
Install the inner fork bolt using the fork cylinder holder.
Special Tool - Fork Cylinder Holder: 57001–1502
Torque - Inner Fork Bolt: 98 N·m (10 kgf·m, 72 ft·lb)
•
Install:
Rubber Stopper
•
Screw the joint rod nut stopped on to the joint rod.
Both Fork Legs:
•
Replace the O-ring [A] with a new one.
•
Apply grease to the O-ring.
•
Screw in the top plug [B] stopped onto the piston rod or
joint rod.
•
Holding the top plug [A] with a wrench, tighten the piston
rod nut [B] or joint rod nut against the top plug.
Torque - Piston Rod Nut: 20 N·m (2.0 kgf·m, 15 ft·lb)
Joint Rod Nut: 20 N·m (2.0 kgf·m, 15 ft·lb)
•
Raise the outer tube and screw the top plug into it and
install it.
Torque - Front Fork Top Plug: 34 N·m (3.5 kgf·m, 25 ft·lb)
•
Install the front fork (see Front Fork Installation).
SUSPENSION 13-11
Comments to this Manuals
Latest comments: