Rear Master Cylinder Installation
Replace the cotter pin with a new one.
Insert the cotter pin [A] to the hole of the joint pin [B] and
separate [C] the cotter pin ends.
Use a new flat washer on each side of the brake hose
Torque - Rear Master Cylinder Mounting Bolts: 25 N·m (2.5
kgf·m, 18 ft·lb)
Brake Hose Banjo Bolt: 25 N·m (2.5 kgf·m, 18 ft·lb)
Bleed the brake line (see Brake Line Bleeding).
Check the brake for good braking power, no brake drag,
and no fluid leakage.
Do not attempt to ride the motorcycle until a full
brake pedal is obtained by pumping the brake pedal
until the pads are against the disc. The brake will
not function on the first application of the pedal if
this is not done.
Front Master Cylinder Disassembly
Remove the front master cylinder.
Remove the reservoir cap, plate and diaphragm.
Unscrew the locknut and pivot bolt, and remove the brake
Pull the dust cover [A] out of place, and remove the circlip
Special Tool - Inside Circlip Pliers: 57001-143
Pull out the piston assy [C], primary cup [D], and return
Do not remove the secondary cup from the piston
since removal will damage it.