Front Caliper Removal
Loosen the banjo bolt [A] at the brake hose lower end,
and tighten it loosely.
Unscrew the caliper mounting bolts [B].
Do not loosen the caliper assembly bolts [C]. Take
out only the caliper mounting bolts for caliper re-
moval. Loosening the caliper assembly bolts will
cause brake fluid leakage. Immediately wash away
any brake fluid that spills.
Take off the caliper.
Unscrew the banjo bolt and remove the brake hose from
Rear Caliper Removal
Caliper Mounting Bolts [A]
Brake Hose [B]
Rear Caliper [C]
Install the caliper and brake hose lower end.
Replace the washer on each side of hose fitting with new
Tighten the caliper mounting bolts and banjo bolt.
Torque - Front Caliper Mounting Bolts: 34 N·m (3.5 kgf·m,
Rear Caliper Mounting Bolts: 34 N·m (3.5 kgf·m,
Brake Hose Banjo Bolt: 25 N·m (2.5 kgf·m, 18 ft·lb)
Check the fluid level in the brake reservoirs.
Bleed the brake line (see Brake Line Bleeding).
Check the brake for good braking power, no brake drag,
and no fluid leakage.
Do not attempt to ride the motorcycle until a full
brake lever or pedal is obtained by pumping the
brake lever or pedal until the pads are against the
disc. The brakes will not function on the first appli-
cation of the lever or pedal if this is not done.