Brake Lever, Brake Pedal
Pull out the brake pedal [B] from the right footpeg bracket
Brake Pedal Installation
Apply grease to the brake pedal shaft.
Install the pedal shaft [A] so that the punched mark on the
shaft is aligned [B] with the punched mark on the brake
Brake Pedal Return Spring
Brake Switch Return Spring
Torque - Brake Pedal Clamp Bolt: 25 N·m (2.5 kgf·m, 18
Rear Master Cylinder Mounting Bolts: 25 N·m (2.5
kgf·m, 18 ft·lb)
Replenish the fluid in the reservoir, and bleed the brake
line (see Brake Line Bleeding).
Check the brake for proper braking power, no brake drag,
and no fluid leakage.
Do not attempt to ride the motorcycle until a full
brake pedal is obtained by pumping the brake pedal
until the pads are against the disc. The brake will
not function on the first application of the pedal if
this is not done.
Check the brake pedal position and adjust it if necessary.
Check the rear brake light switch operation and adjust the
switch if necessary (see Periodic Maintenance chapter).