Hub Bearings (Wheel Bearings)
Hub Bearings Removal
Remove the wheel, and take out the following.
Grease Seals [A]
Coupling [C] (Out of Rear Hub)
Front Hub [D]
Rear Hub [E]
Special Tool - Inside Circlip Pliers: 57001-143
Use the bearing remover to remove the hub bearings [A].
Do not lay the wheel directly on the ground with
the disc facing down. This can damage or warp the
disc. Place blocks under the wheel so that the disc
does not touch the ground.
Special Tools - Bearing Remover Shaft, 13:
Bearing Remover Head, 25 × 28:
57001-1346 [C] (For Front Hub)
Bearing Remover Head, 20 × 22:
57001-1293 [C] (For Rear Hub)
Hub Bearings Installation
Before installing the wheel bearings, blow any dirt or for-
eign particles out of the hub with compressed air to pre-
vent contamination of the bearings.
Replace the bearings with new ones.
Install the bearings so that the marked side faces out.
Install the bearings by using a bearing driver.
First, press each right bearing [A] in until it bottoms out.
Special Tool - Bearing Driver Set: 57001-1129 [B]
Next, install the following: