Fit the alignment tooth [A] of the splines of the right bal-
ancer [B] onto the alignment notch of the balancer shaft.
Install the starter torque limiter [A] and washer [B].
Install the collar [C], copper washer [D], and needle bear-
ing [E] in the order listed.
The copper washer must be on the collar.
Push the starter clutch gear [A] in and turn it clockwise [B]
and install it.
Apply molybdenum disulfide oil to the threads and seat-
ing surface of the starter clutch bolt and tighten it to the
specified torque while holding the primary gear bolt.
The molybdenum disulfide oil is a mixture of engine oil
and molybdenum disulfide grease with a weight ratio (10
Torque - Starter Clutch Bolt: 85 N·m (8.7 kgf·m, 63 ft·lb)
Be sure to install the washer [C] onto the torque limiter.
Shift Mechanism (see External Shift Mechanism Instal-
Damper Cam and Front Gear Case (see Final Drive
Clutch (see Clutch chapter)
Water Pump (see Cooling System chapter)
Engine Top End (see Engine Top End chapter)
Alternator Inner Cover, Alternator Cover, Alternator
Outer Cover (see Electrical System chapter)