Remove all the left crankcase bolts in the order listed.
6 mm Bolts (14) [A]
8 mm Bolt (1) [B]
10 mm Bolts (3) [C]
Turn the left crankcase down.
Lift up the right crankcase.
Using the pry points, split the crankcase halves.
Pry Point (Front) [A]
Pry Point (Rear) [B]
Remove the following from the left crankcase.
Transmission Gear Assy (see Transmission Removal)
With a high-flash point solvent, clean off the mating sur-
faces of the crankcase halves and wipe dry.
Using compressed air, blow out the oil passages in the
Support the crankcase bearing boss with a suitable re-
Using a press and the bearing driver set [C], install a new
bearing [B] by pushing the bearing outer race until it bot-
Support the crankcase bearing boss when pushing
the bearing, otherwise the crankcase could be dam-
Press the three needle bearings with manufacturer's
marks facing out into holes on the right side of the right
crankcase. Push the needle bearing outer race until the
face of the bearing is even with the end of the hole, using
Special Tool - Bearing Driver Set: 57001–1129