Engine (see Engine Removal/Installation chapter)
Cylinder Blocks (see Engine Top End chapter)
Pistons (see Engine Top End chapter)
Clutch (see Clutch chapter)
Front Gear Case (see Final Drive chapter)
Alternator Inner Cover (see Electrical System chapter)
Remove the shift shaft [A] while pushing [B] the shift
mechanism arm [C] towards the shift shaft.
Unscrew the bolt [D] and remove the gear set lever [E]
and its spring [F].
Remove the retainer [A] and needle bearing [B] from the
Special Tool - Outside Circlip Pliers: 57001–144
Remove the crankcase bearing upper retainer bolts [C]
and retainer [D].
Remove the clutch push rod guide [A] and bolts.
Insert a bolt ( 12 mm, L 100 mm) [B] into the engine
mounting bolt hole.
Unscrew the damper cam nut [C] using the damper cam
holder [D] (special tool) and deep socket wrench.
Special Tool - Damper Cam Holder: 57001-1025
Pull the starter clutch gear [A] out of the starter clutch (The
starter clutch gear can be removed with the engine in the