8-8 ENGINE REMOVAL/INSTALLATION
Apply a thin coat of high temperature grease to the driven
gear joint and to the propeller shaft joint.
Push on the lockpin [A] and move back the engine to en-
gage the front bevel gear joint with the propeller shaft
Run the brake hose [A] and the clutch hose [B] inside the
frame [C] as shown.
Insert the rear mounting bolt from the left side of the en-
gine to set the engine into its original position in the frame.
Torque - Downtube Bolts and Nuts: 44 N·m (4.5 kgf·m, 32
Engine Mounting Bolts and Nuts: 44 N·m (4.5
kgf·m, 32 ft·lb)
Engine Mounting Bracket Bolts:
kgf·m, 18 ft·lb)
Run the leads, cables and hoses correctly (see Cable,
Wire and Hose Routing section in the Appendix chapter).
Connect the engine ground lead [A] down to the engine
Torque - Engine Ground Terminal Bolt: 7.8 N·m (0.80 kgf·m,
25 N·m (2.5