Oil Pump and Oil Line
Install the inside oil pipe [A], separator [B], and the oil
return pipe [C] to the right crankcase [D].
Do not apply silicone sealant to the groove of the grommet
and the mating surface of the grommet [E].
Install the separator so that it's smaller side [F] faces in-
Apply a non-permanent locking agent to the oil pipe holder
bolt [G], oil return pipe clamp bolts [H] and oil pipe clamp
If the oil nozzle [J] is removed, install it.
Torque - Oil Pipe Holder Bolt: 11 N·m (1.1 kgf·m, 97 in·lb)
Oil Return Pipe Clamp Bolt: 11 N·m (1.1 kgf·m, 97
Oil Pipe Clamp Bolt: 11 N·m (1.1 kgf·m, 97 in·lb)
Oil Nozzle: 2.9 N·m (0.30 kgf·m, 26 in·lb)
Install the removed parts.
Blowby Gas System Inspection
Be certain that all the hoses are routed without being flat-
tened or kinked, and are connected correctly to the oil
reserve tank and right air cleaner base.
If they are not, correct them.
Inspect the breather hoses [A], breather pipe [B], and the
air cleaner drain hose for damage or signs of deteriora-
These hoses should not be hard and brittle, nor should be
soft or swollen.
Replace it if any cracks or swelling are noticed.
Check that the hoses are securely connected.
ENGINE LUBRICATION SYSTEM 7-13