7-10 ENGINE LUBRICATION SYSTEM
Oil Pump and Oil Line
Oil Hose Installation
Run the front oil hose over the rear oil hose as shown.
Insert the rear oil hose [A] first.
Next insert the front oil hose [B].
Run both oil hoses between the rocker case and the
rocker case cover.
Torque - Oil Hose Flange Bolts: 9.8 N·m (1.0 kgf·m, 87 in·lb)
Install the clamps [C].
Fit the clamp [D] as shown.
Install each bottom end of the oil hoses on the right
crankcase behind the rear cylinder as shown.
Front Oil Hose [A]
Rear Oil Hose [B]
Face the paint marks [D] rearward.
Replace the copper washers on each side of the banjo
bolt with new ones.
Torque - Oil Hose Banjo Bolt [E]: 9.8 N·m (1.0 kgf·m, 87
Install the removed ports.
Inside Oil Pipe Removal
Split the crankcase (see Crankshaft/Transmission chap-
Oil Pipe Clamp Bolts [A]
Oil Pipe Holder Bolt [B]
Remove the inside oil pipe [C] from the right crankcaes.