Clutch Slave Cylinder
Tighten the bolts [A].
Torque - Clutch Slave Cylinder Bolts: 6.9 N·m (0.70 kgf·m,
Put the clamp [B] together the clutch slave cylinder bolt
and bend along the slave cylinder with the end of the
clamp straight to the engine side as shown in the figure.
This clamp is to prevent the edge of the slave cylinder
from damaging the wire, not to clamp the wire.
Replace the washers on each side of the clutch hose fit-
ting with new ones.
Tighten the banjo bolt [C] to the specified torque.
Torque - Clutch Pipe Banjo Bolt: 25 N·m (2.5 kgf·m, 18 ft·lb)
Check the fluid level in the master cylinder reservoir, and
bleed the air in the clutch line.
Check the clutch operation.
Clutch Slave Cylinder Disassembly/Assembly
Refer to Clutch Slave Cylinder Piston Seal Replacement
in the Periodic Maintenance Chapter.