Tighten the front exhaust pipe cover clamp screw [A] with
its head inclined at 50° or less to horizontal as shown.
This prevents the screw from touching ground when bank-
Front Exhaust Pipe [B]
Torque - Exhaust Pipe Cover Clamp Screws: 6.9 N·m (0.70
kgf·m, 61 in·lb)
First, tighten all the bolts and nuts to a snug fit.
Secondary, tighten the exhaust pipe holder nuts evenly.
Finally, tighten the rest of the mounting bolts and clamp
Thoroughly warm up the engine, wait until the engine
cools down, and retighten all the clamp bolts.
Front Exhaust Pipe [A]
Rear Exhaust Pipe [B]
Lower and Upper Mufflers [C]
Right and Left Chamber Bolts [D]
Take out the premuffler chamber [E].
Replace the muffler flange gasket with new ones.
Install the exhaust pipe and muffler pipe clamps [A] with
its bolt downward.
Torque - Chamber Bolts: 29 N·m (3.0 kgf·m, 21 ft·lb)
Apply a soap and water solution or rubber lubricant to the
surface of the rubber bushings and install them into the
brackets of the chamber as shown (Top View).
Rubber Bushings [A] ( 24.8 mm (0.976 in.)) with a
raised ring [B]
Rubber Bushings [C] ( 25.3 mm (0.996 in.)) without
ENGINE TOP END 5-49