If a new piston or cylinder is used, check piston to cylin-
der clearance (see Piston/Cylinder Clearance), and use
new piston ring.
Replace the cylinder base gasket [A] with a new one, and
install the gaskets aligning the holes with the crankcase
water passages [B].
Be sure to install the dowel pins [C].
Using the piston ring compressor assembly [A] with the
chamfered side [B] upward, install the cylinder block [C].
Special Tools - Piston Ring Compressor Grip: 57001-1095
Piston Ring Compressor Belt, 95 ~ 108:
The front cylinder [A] has an F mark and the rear cylinder
[B] has an R mark. Be careful not to mix them up.
Insert the chain guide into the cylinder.
The front chain guide for the front cylinder has an F mark
[A] and the front chain guide for the rear cylinder has an
R mark [B]. Be careful not to mix up these chain guides
since the front chain guide for the rear cylinder is longer.
ENGINE TOP END 5-43