5-18 ENGINE TOP END
Camshaft Chain Tensioner
Install the larger spring [A], and then the ball bearing assy
Fit the ball bearing assy into the body until it bottoms out,
using a thin-bladed screwdriver.
Screw in the lockbolt [A] finger-tight to hold the ball bear-
ing assy temporarily.
Install the retainer [B].
Install the tensioner body [A] and tighten the mounting
bolts [B] to the specified torque.
Torque - Chain Tensioner Mounting Bolts: 11 N·m (1.1
kgf·m, 97 in·lb)
Install the smaller spring [A] and the tensioner cap [B].
Set the spring end into the hollow [C] of the cap.
Tighten the tensioner cap to the specified torque.
Torque - Chain Tensioner Cap: 20 N·m (2.0 kgf·m, 15 ft·lb)
Remove the lockbolt [A] and check to be sure that the
larger spring clicks, then install the lockbolt.
Torque - Chain Tensioner Lockbolt: 4.9 N·m (0.50 kgf·m, 43