Fit the fuel return hose [A] onto the pipe fully and install
the plate clamp [B] beyond the raised rib [C].
Secure the fuel pump leads [A] with the clamps [B].
Press the clamps flat by hands against the fuel tank bot-
Make sure that the end of each clamp is covered with a
plastic cap [C] and touches the fuel tank bottom.
Clamp the fuel pump leads and clamp on the fuel tank
bottom as shown with the strap [D].
Connect portion of strap push in the fuel tank bottom side.
Must not cut off the strap end.
Lack of the clamp cap and protruding of these
clamps could damage the electrical harness.
Connect the fuel pump connector and the battery (−) lead
Install the fuel tank and the indicator unit.
Fuel Tank and Cap Inspection
Visually inspect the gasket [A] on the tank cap for any
Replace the gasket if it is damaged.
Check to see if the breather pipe [B] in the tank is not
If the breather pipe is clogged, blow the breather free with
Do not apply compressed air to the air vent holes
[D] in the tank cap. This could damage and clog the
labyrinth in the cap.
FUEL SYSTEM (DFI) 3-107